(855) 289-1874
Case Studies
Universal Robots Cable-Management Sleeve
PROBLEM:A customer needed an inexpensive, universal robots cable-management solution for electrical and pneumatic lines that run from the base of a 6-Axis, collaborative, robotic arm to the tool head. The robotic arm range of motion, as well as the size and quantity of control lines runn...
Read More →
Missile Canard Retention Sleeve
PROBLEM:A military customer requested an inexpensive solution to retain missile canards in a retracted condition while missiles were in storage crates and attached to Helicopter launch pylons prior to flight. The part needed to be disposable, yet able to withstand all military operation environments...
Read More →
EMI Shielding as a Dielectric Test Medium
A customer requested a solution that could utilize a reusable EMI Shielding cloth to create a 50,000 volt differential for testing molded-Polyethylene utility pole crane buckets. PROBLEM: A customer requested a solution that could utilize a reusable EMI Shielding cloth to create a 50,000 volt diffe...
Read More →
EMI Shielding of Festoon Cables
A customer requested a solution to an EMI-hardening problem on pre-existing festoon cables. The new easy-to-install EMI Shield jacket supplied to the customer did the job. PROBLEM:A customer requested a solution to an EMI-hardening problem on pre-existing festoon cables. The cabling followed a lift...
Read More →
Sealed Yacht Splice
PROBLEM: A custom yacht manufacture was experiencing corrosion of large-diameter grounding cable splices. The salt-laden environment was corroding the crimped copper splice device and exposed cable conductors throughout the yacht. The solution needed to provide an environmentally-sealed cover and ac...
Read More →
Insuflect® Heat Barrier
Problem Extreme heat (650°C) is required during the re-burning of particulates in the After Treatment Device (ATD) as required by the recent EPA standards for cleaner vehicle emissions. Additionally, the heat must be maintained at these elevated temperatures during the entire process. Only a...
Read More →
Protective High Temperature Resistant Jacket
PROBLEM: An industrial machine metalworking customer needed to protect machine power and signal circuitry from hot metal shavings and grinding debris over moderate-length cable runs. Although the metal particulates were not molten, they typically had a temperature range of 250-400°F for a few secon...
Read More →
Printed Circuit Board EMI Shield Pouch
PROBLEM:A U.S. Homeland Security agency required EMI hardening of a classified electronic system and had discovered, after shielding all interconnect cables, that the source of the EMI leakage problem emanated from the main printed circuit board. MATERIAL:The shielded assembly consisted of an inner...
Read More →
Space Shuttle Helium Barrier Bag
PROBLEM: Space Shuttle main engine fuel lines required encapsulation with a removable device that could contain gaseous Helium and ensure no build-up of flammable liquid Hydrogen in the compartment. SOLUTION: A lightweight, inflatable, zip-on bag was designed that could be wrapped around the ...
Read More →
A Portable Shielding Enclosure For EMC Testing
Read As PDF SHIELDED ROOMS - Faraday Cage A Portable Shielding Enclosure For EMC Testing Interference Technology Engineers’ Master (ITEM) - 1995The International Journal of EMC™Directory & Design Guide for the control of EMI & (other) E3 BACKGROUND Inexpensive soli...
Read More →
